Ultrasonic Facial Instructions


How to use - Deep Cleanse Treatment

How to use - Deep Cleanse Treatment

Step 1: Apply warm water to your clients face using a face cloth or flannel.  The skin must remain wet during the entire treatment.  Never use the device on dry skin.

Step 2: Turn unit on by pressing the power button until the unit engages.  This will automatically begin in cleaning mode.

Step 3: Hold the unit so that the control panel is away from the skin.

Step 4: With gentle pressure, scrape the blade over the skin using a forward movement.  You will see a fine spray of water droplets and dead skin cells being collected on the end of the blade. For best results, take your time and work slowly moving the blade at all times.

Step 5: Methodically work over all areas of the face.  Pay special attention to the corners of the nose as this area will usually produce the most extractions.  Wipe the blade when required.

Step 6: After use, turn the unit off by pressing the power button until the unit turns off. The blade may be cleaned by wiping with a damp cloth. Store the device with the protective silicone sleeve on the blade. Note: If left on, the unit will automatically turn off after 10 minutes.


IMPORTANT:- ENSURE THE DEVICE IS STERILISED WITH MEDICAL GRADE ALCOHOL WIPES BETWEEN CLIENTS.

Read More
How to use – Absorb Treatment

How to use – Absorb Treatment

Step 1: Apply a layer of serum to the face. If the face becomes dry during the treatment add more serum or lotion.

Step 2: Turn unit on by pressing the power button until the unit engages. Select absorb by pressing the power button once.  This will engage the pulsing wave programme.

Step 3: Hold the unit so that the control panel is towards the skin.

Step 4: With gentle pressure, glide the blade over the surface of the skin using a backward motion.  This time you are dragging the blade instead of pushing it over the skin. The serum will gradually be absorbed deep into the skin. For best results, take your time and work slowly moving the blade at all times.

Step 5: Methodically work over all areas of the face.

Step 6: After use, turn the unit off by pressing the power button until the unit turns off. The blade may be cleaned by wiping with a damp cloth. Store the device with the protective silicone sleeve on the blade. Note: If left on, the unit will automatically turn off after 10 minutes.


IMPORTANT:- ENSURE THE DEVICE IS STERILISED WITH MEDICAL GRADE ALCOHOL WIPES BETWEEN CLIENTS

Read More
How to use – Repair Treatment

How to use – Repair Treatment

Step 1: Apply a generous amount of moisturiser to the face.

Step 2: Turn unit on by pressing the power button. Select absorb by pressing the power button twice.  

Step 3: Hold the unit so that the control panel is towards your skin.

Step 4: With gentle pressure, glide the blade over the surface of the skin using a backward motion.  This time you are dragging the blade instead of pushing it over the skin. The serum will gradually be absorbed deep into the skin. For best results, take your time and work slowly moving the blade at all times.

Step 5: Methodically work over all areas of the face.

Step 6: After use, turn the unit off by pressing the power button until the unit turns off. The blade may be cleaned by wiping with a damp cloth. Store the device with the protective silicone sleeve on the blade. Note: If left on, the unit will automatically turn off after 10 minutes.


IMPORTANT:- ENSURE THE DEVICE IS STERILISED WITH MEDICAL GRADE ALCOHOL WIPES BETWEEN CLIENTS

Read More
This site was built using